Calculate<Chn>:Data; Calculate:data:all - R&S ZNB Series User Manual

®
R&S ZNB/ZNBT
Error Term
SCORr14
SCORr15
SCORr16
SCORr17
SCORr18
SCORr19
SCORr20
SCORr21
SCORr22
SCORr23
SCORr24
SCORr25
SCORr26
SCORr27
Note: The error terms are channel-specific; they apply to the active calibration of chan-
nel no. <Chn> or to the factory calibration (if no channel calibration is active). For the
factory calibration, the query form is allowed only (no change of factory calibration
data).
Tip: Use the generalized command
write error terms for arbitrary analyzer ports. For additional programming examples
refer to
CALCulate:DATA:ALL? <Format>[, <RecallSet>]
Reads the current response values of all traces of the referenced recall set.
Query parameters:
<Format>
<RecallSet>
Return values:
<Data>
Example:
Usage:
User Manual 1173.9163.02 ─ 62
Description
Source match
Reflection tracking
Isolation
Load match
Transmission tracking
Isolation
Load match
Transmission tracking
Isolation
Load match
Transmission tracking
Isolation
Load match
Transmission tracking
Chapter 8.2.5.3, "Saving and recalling error
FDATa | SDATa | MDATa
Output format for the S-parameter data, see
CALCulate<Chn>:DATA.
Recall set name; if omitted the active recall set is used
Response values either in ASCII or block data format, depend-
ing on the current
See
CALCulate<Chn>:DATA
Query only
[SENSe<Ch>:]CORRection:CDATa
terms",
FORMat[:DATA]
Command reference
SCPI command reference
Receive Ports (S-parameter)
3 (S33)
3 (S33)
3 (S31)
3 (S31)
3 (S13)
1 (S13)
1 (S13)
1 (S13)
3 (S32)
3 (S32)
3 (S32)
2 (S23)
2 (S23)
2 (S23)
to read or
on page 1518.
setting.
849