R&S ZNB Series User Manual page 476

®
R&S ZNB/ZNBT
functionality is the same as described for the "SingleCal" version of the wizard (see
"Step 2: Connectors and Cal Kits"
Back
Go back to
Start
Start
Step 3: Calibration
Allows you to acquire error correction data for every required port (pair) and calibration
standard, where "required" depends on the selected ports and calibration types.
Same logic as in the single calibration version of the wizard (see
on page 468).
The possibility to "share" measurements between the calibrations and the "Reduced
Through" logic help to keep the number of measurements as small as possible (see
Chapter 4.5.1.11, "Full n-Port calibration with reduced number of Through connec-
tions",
5.11.1.7 Power Cal wizard
The "Power Cal" wizard displays a single screen, showing the current source and
receive ports. It allows you to perform "Ref. Receiver", "Meas. Receiver" and scalar
source power ("Source Flatness") calibrations, based on the current power calibration
settings (see
Access: Channel – [Cal] > "Start Cal" > "Power Cal..."
User Manual 1173.9163.02 ─ 62
Step 1: Ports and
Step 3: Calibration.
on page 173).
Chapter 5.11.3, "Pwr Cal Settings
on page 465).
Type.
tab",
GUI reference
Cal softtool
"Step 3: Calibration"
on page 524).
476