R&S ZNB Series User Manual page 939

®
R&S ZNB/ZNBT
Parameters:
<Boolean>
Example:
Manual operation:
CALCulate<Chn>:LIMit:STATe:AREA <HorizontalPos>, <VerticalPos>
Moves the limit check pass/fail message for the active trace <Chn> to one of nine pre-
defined positions in the active diagram.
Suffix:
<Chn>
Parameters:
<HorizontalPos>
<VerticalPos>
Example:
Manual operation:
CALCulate<Chn>:LIMit:TTLout<Pt>[:STATe] <Boolean>
Switches the TTL pass/fail signals on or off. The signals are applied to the USER
PORT as long as the active trace <Chn> is within limits, including the ripple limits.
See
Default values for new traces can be set using
STATe].
Suffix:
<Chn>
<Pt>
Parameters:
<Boolean>
User Manual 1173.9163.02 ─ 62
ON | OFF - Limit check on or off.
*RST:
*RST; CALC:LIM:CONT 1 GHZ, 2 GHZ
Define an upper limit line segment in the stimulus range
between 1 GHz and 2 GHz, using default response values.
CALC:LIM:STAT ON; FAIL?
Switch the limit check on and query the result.
See
.
Channel number used to identify the active trace
LEFT | MID | RIGHt
Horizontal position
TOP | MID | BOTTom
Vertical position
See
See
Chapter 12.3.1.1, "User
.
Channel number used to identify the active trace
1 - TTL out pass 1 (pin 13 of User Port connector)
2 - TTL out pass 2 (pin 14 of User Port connector)
ON | OFF - TTL output signal on or off.
*RST:
OFF
"Limit Check" on page 375
CALCulate<Chn>:LIMit:FAIL?
"Limit Check" on page 375
Port", on page 1538.
SYSTem:TTLout<Pt>:STATus[:
OFF
Command reference
SCPI command reference
939