R&S ZNB Series User Manual page 297

®
R&S ZNB/ZNBT
Remote command:
CALCulate<Ch>:PARameter:MEASure
CALCulate<Ch>:PARameter:SDEFine
Detector
Selects the algorithm that is used to calculate the results points from the raw measure-
ment data.
For details refer to
Remote command:
CALCulate<Ch>:PARameter:MEASure
CALCulate<Ch>:PARameter:SDEFine
[SENSe<Ch>:]SWEep:DETector:TIME
5.2.3 Wave tab
Selects wave quantities as measured quantities.
Background information
Refer to
5.2.3.1 Controls on the Wave tab
The "More Wave Quantities..." button opens the
allows to select an arbitrary
numbers.
a<i> Source Port <i>, b<j> Source Port <i>
Selects one of the standard 2-port
The predefined wave quantities are obtained with different source ports. "a1 Source
Port 1", "b1 Source Port 1" and "b1 Source Port 2" are measured at Port 1 of the ana-
lyzer. "a2 Source Port 2, b2 Source Port 1" and "b2 Source Port 2" are measured at
Port 2 of the analyzer.
User Manual 1173.9163.02 ─ 62
Chapter 4.3.5.3, "Detector
Chapter 4.3.5, "Wave quantities and
wave
"<Trace_Name>", "<Ratio>"
"<Trace_Name>", "<Ratio>"
settings", on page 136.
ratios", on page 135.
More Wave Quantities
quantity, e.g. for different source ports or higher port
wave quantities a , b for different source ports.
i j
GUI reference
Meas softtool
dialog which
297