R&S ZNB Series User Manual page 414

®
R&S ZNB/ZNBT
●
While in Cartesian diagrams the x-axis represents the stimulus values, in polar and
Smith diagrams this direct relation is lost. In any case, a marker can be used to dis-
play the stimulus value of a given trace point.
For "Time Domain" traces, points in the "observation interval" are interpreted as
stimulus values.
●
All stimulus settings except the "Time Domain X-Axis" settings are channel set-
tings. "Time Domain X-Axis" applies to the active (time domain) trace only.
Background information
Refer to the following sections:
●
Chapter 4.1.3, "Traces, channels and
●
Chapter 3.3.7.2, "Setting the sweep
●
Chapter 3.3.7.6, "Set by
5.8.1 Stimulus tab
Defines the sweep range in the current channel, depending on the sweep type.
Related Settings
Refer to the following sections:
●
Chapter 4.1.4.4, "Stimulus and sweep
●
Chapter 5.10.2, "Sweep Type
The following "Stimulus" settings are also available on the "Power" tab:
●
Power
●
Start Power / Stop Power
Start Frequency / Stop Frequency / Center Frequency / Span Frequency
Defines the sweep range for non-segmented frequency sweeps.
For a
quency" and "Span Frequency" are alternatives.
User Manual 1173.9163.02 ─ 62
Lin Freq sweep, setting "Start Frequency" and "Stop Frequency" or "Center Fre-
diagrams",
range", on page 74
marker", on page 76
types", on page 96
tab", on page 426
GUI reference
Stimulus softtool
on page 88
414