R&S ZNB Series User Manual page 839

®
R&S ZNB/ZNBT
6.5.5 Reset values of the status reporting system
The table below indicates the effects of various commands upon the status reporting
system of the R&S ZNB/ZNBT.
DCL, SDC (Device Clear, Selected Device Clear)
Event
Effect
Clear STB, ESR
Clear SRE, ESE
Clear PPE
Clear EVENt parts of the reg-
isters
Clear ENABle parts of all
OPERation and QUESTiona-
ble registers,
Fill ENABle parts of all other
registers with "1".
Fill PTRansition parts with "1"
Clear NTRansition parts
Clear error queue
Clear output buffer
Clear command processing
and input buffer
1) Every command being the first in a command line, i.e. immediately following a
<PROGRAM MESSAGE TERMINATOR> clears the output buffer.
User Manual 1173.9163.02 ─ 62
Switching on DCL, SDC
supply voltage (Device
Power-On-Status- Clear,
Clear Selected
Device Clear)
0 1
yes
yes
yes
yes
yes
yes
yes yes
yes yes yes
yes yes yes
Remote control
Status reporting system
*RST or STA-
Tus:PRE-
SYS-
Set
Tem:PRE-
Set:ALL
yes
yes
1) 1)
*CLS
yes
yes
yes
1)
839