R&S ZNB Series User Manual page 643

®
R&S ZNB/ZNBT
CALCulate<Ch>:TRANsform:VNETworks:PPAir:EMBedding<ListId>:
PARameters:R<1|2|3>
CALCulate<Ch>:TRANsform:VNETworks:PPAir:EMBedding<ListId>:
PARameters:G<1|2|3>
D1, D2
The "D1" (and "D2") buttons are enabled as long as the selected deembedding/embed-
ding network is defined using Touchstone files.
When loading a touchstone file, the analyzer by default assumes odd ports left (VNA
side), even ports right (DUT side). However, it is also possible to instruct the analyzer
to assume an "Increasing Port Sequence", i.e. that the low port numbers are on the
VNA side. Furthermore it is possible to "Swap Gates", i.e. to instruct the analyzer to
swap the VNA and DUT side.
Note: The loaded file is stored in the active recall set. Persisted recall sets contain the
full de-/embedding data so that they can be transferred to other instruments.
Remote command:
MMEMory:LOAD:VNETworks<Ch>:PPAir:DEEMbedding<ListId>
MMEMory:LOAD:VNETworks<Ch>:PPAir:EMBedding<ListId>
5.13.7 Balanced tab
Selects 4-port transformation networks for balanced port deembedding/embedding,
defines their parameters, assigns them to a balanced port and enables embedding.
Use the complementary dock widget to create
tivate dembedding/embedding for selected balanced ports (see
anced
Background information
Refer to the section
on page 219.
User Manual 1173.9163.02 ─ 62
panel", on page 611).
Chapter 4.6.2.10, "Combining Several de-/embedding
Offset Embed softtool
Balanced panel and to activate or deac-
Chapter 5.13.1.5, "Bal-
GUI reference
networks",
643