R&S ZNB Series User Manual page 662

®
R&S ZNB/ZNBT
If either multiple DUTs are configured (see
ment
nel (see
(grayed out).
5.13.12.1 Delta-L Settings dialog
From the "Detal-L Settings" dialog, you can set up the Delta-L measurement channel
and how the external tool is run.
Access: Channel – [Offset Embed] > "Delta-L" > "Delta-L Settings..."
Method
Selects the Delta-L+ characterization method to be used. Default is "Method 2L". For
background information, see
"Method 1L" handles single-ended and balanced measurement results differently; acti-
vate "1L Diff. Mode" for balanced measurements. For "Method 2L" and "Method 3L"
measurements can also be single-ended or balanced, but the tool does not distinguish
between them.
Remote command:
CALCulate:FMODel:DELT:METHod
CALCulate:FMODel:DELT:M1L:DIFFmode
Measurements
Defines whether single-ended or balanced ports are measured for Delta-L characteri-
zations.
User Manual 1173.9163.02 ─ 62
dialog", on page 570) or the "Fixture Simulator" is disabled for the related chan-
"Fixture Simulator" on page 549), the "Balanced Ports..." button is inactive
Chapter 5.12.2.3, "Define Parallel Measure-
Delta-L 4.0 PCB characterization.
GUI reference
Offset Embed softtool
662