R&S ZNB Series User Manual page 896

®
R&S ZNB/ZNBT
CALCulate:FMODel:DELT:FREQuencies:USEDefault <Boolean>
Delta-L computes the uncertainty in the loss-per-inch calculation at specified frequen-
cies.
This command specifies whether to use the tool's default frequencies or custom fre-
quencies, which can be defined using
Quencies:USER
Parameters:
<Boolean>
Options:
Manual operation:
CALCulate:FMODel:DELT:FREQuencies:USER?
The Delta-L algorithm can calculate the loss-per-inch uncertainties either at default or
at custom frequencies (see
USEDefault).
This command returns the custom frequencies, defined using
DELT:FREQuencies:USER:ADD
Usage:
Options:
Manual operation:
CALCulate:FMODel:DELT:FREQuencies:USER:ADD <UserFrequencies>
CALCulate:FMODel:DELT:FREQuencies:USER:DELete <Frequency>
The Delta-L algorithm can calculate the loss-per-inch uncertainties either at default or
at custom frequencies (see
USEDefault).
CALCulate:FMODel:DELT<Ph_pt>:FREQuencies:USER:ADD|DELete adds/
deletes a frequency to|from the list of custom frequencies.
Setting parameters:
<Frequency>
Usage:
Options:
Manual operation:
User Manual 1173.9163.02 ─ 62
CALCulate:FMODel:DELT<Ph_pt>:FRE
commands.
ON (1)
Use default frequencies
OFF (0)
Use custom frequencies
R&S ZNB/ZNBT-K231
See "Frequencies"
CALCulate:FMODel:DELT:FREQuencies:
etc.
Query only
R&S ZNB/ZNBT-K231
See "Frequencies"
CALCulate:FMODel:DELT:FREQuencies:
Custom frequency
Range: The frequency range of the analyzer
Default unit: Hz
Setting only
R&S ZNB/ZNBT-K231
See "Frequencies"
Command reference
SCPI command reference
on page 663
CALCulate:FMODel:
on page 663
on page 663
896