R&S ZNB Series User Manual page 466

®
R&S ZNB/ZNBT
Background information
Refer to
Messages in the dialog
An information message (or error message) is displayed if one of the following hap-
pens:
●
One of the selected calibration kits is described by ideal kit parameters or typical
values.
●
One of the selected calibration kits does not contain all standards that are required
for the previously selected calibration type.
●
Different connector types are defined at the ports but the selected calibration type
requires uniform connectors.
●
A cal kit standard does not cover the entire calibrated frequency range.
Figure 5-22: Calibration Setting Wizard, Step 2: Connectors and Cal Kits
The upper part of the panel shows the ports and the calibration type selected in
Ports and
If more than 4 ports are available, the GUI is slightly different:
User Manual 1173.9163.02 ─ 62
Chapter 4.5.2, "Calibration standards and calibration
Type. The lower part gives access to the connector and cal kit settings.
GUI reference
Cal softtool
kits", on page 174.
Step 1:
466