R&S ZNB Series User Manual page 832

®
R&S ZNB/ZNBT
Bit No.
4
5
6
7
Related common commands
The Event Status Register (ESR) can be queried using ESR?. The Event Status Enable
(ESE) register can be set using the command *ESE and read using *ESE?.
See also
6.5.3.4 STATus:OPERation
The STATus:OPERation register contains conditions which are part of the instrument's
normal operation. The analyzer does not use the STATus:OPERation register.
6.5.3.5 STATus:QUEStionable
The STATus:QUEStionable register indicates whether the acquired data is of ques-
tionable quality and monitors hardware failures of the analyzer. It can be queried using
the commands STATus:QUEStionable:CONDition? or
STATus:QUEStionable:EVENt?.
Bit No.
9
10
STATus:QUEStionable:LIMit<1|2>
The STATus:QUEStionable:LIMit<1|2> registers indicate the result of the limit
check. They can be queried using the commands
STATus:QUEStionable:LIMit<1|2>:CONDition? or
User Manual 1173.9163.02 ─ 62
Meaning
Execution error
This bit is set if a received command is syntactically correct, but cannot be performed for
other reasons. An error message with a number between –200 and –300, which describes
the error in greater detail, is entered into the error queue.
Command error
This bit is set if a command which is undefined or syntactically incorrect is received. An
error message with a number between -100 and -200, which describes the error in greater
detail, is entered into the error queue.
User request
This bit is set when the instrument is switched over to manual control or when a user-
defined softkey is used (see SYSTem:USER:KEY).
Power On (supply voltage on)
This bit is set when the instrument is switched on.
Common commands.
Meaning
INTegrity register summary
This bit is set if a bit is set in the STATus:QUEStionable:INTegrity register and the associ-
ated ENABle bit is set to 1.
LIMit register summary
This bit is set if a bit is set in the STATus:QUEStionable:LIMit1 register and the associated
ENABle bit is set to 1.
Remote control
Status reporting system
832