R&S ZNB Series User Manual page 918

®
R&S ZNB/ZNBT
CALCulate:FMODel:SFD:COUPon:MEASure:FILename <String>
For a fixture modeling with the SFD tool, this command loads the coupon properties
from a Touchstone file.
The coupon type can be selected using CALCulate:FMODel:SFD:COUPon:TYPE.
Parameters:
<String>
Manual operation:
CALCulate:FMODel:SFD:COUPon:MEASure:FILename:CLEar
Invalidates the file path previously set using
MEASure:FILename.
Usage:
Manual operation:
CALCulate:FMODel:SFD<Ph_pt>:COUPon[:STATe] <Boolean>
For a fixture modeling with the SFD tool, this command allows to specify the ports to
which the test coupon is connected.
This has to be defined before measuring the test coupon (using
SFD:DUT:MEASure).
Suffix:
<Ph_pt>
Parameters:
<Boolean>
Manual operation:
CALCulate:FMODel:SFD:COUPon:TYPE <CouponType>
Sets/gets the coupon type to be measured for a fixture modelling with the SFD tool.
Parameters:
<CouponType>
Manual operation:
CALCulate:FMODel:SFD:DIFFcfg <SFDPortConfig>
Tells the SFD tool about the port ordering of the 2x Thru test coupon.
User Manual 1173.9163.02 ─ 62
Path to the Touchstone file, either absolute or relative to the
selected working directory (CALCulate:FMODel:DIRectory).
See "Load File / 1x Open Preset / 1x Short Preset"
CALCulate:FMODel:SFD:COUPon:
Event
See "Load File / 1x Open Preset / 1x Short Preset"
.
Physical port number
1 (ON, true) if the test coupon is connected to port <Ph_pt>, 0
(OFF, false) otherwise
See "Active" on page 631
SYMMetric2x | OPEN1x | SHORt1x
See "Coupon Type" on page 630
Command reference
SCPI command reference
on page 630
on page 630
CALCulate:FMODel:
918