R&S ZNB Series User Manual page 655

®
R&S ZNB/ZNBT
Depending on the selected
test coupon
DUT
The first step in setting up a new deembedding with the "Deembedding Assistant" is to
select the type of DUT. Depending on the number of available test/DUT ports and the
selected
Table 5-7: DUT types
DUT type
"1 x 1 Single Ended"
"1 x Single Ended"
"1 x 1 Balanced"
"1 x Balanced"
"1 x Balanced, 1 x Single Ended"
"2 x 1 Single Ended"
"2 x 2 Single Ended"
"n x Single Ended"
"n x m Single Ended"
"n x Balanced"
"n x m Balanced"
The dock widget presents a graphical representation of the selected "DUT" and
pon models, e.g. for a "1 x 1 Balanced" DUT witch "Balanced " left and right models:
User Manual 1173.9163.02 ─ 62
fixture
models.
fixture tool, choose one of the following DUT types:
Description
1 single-ended input, 1 single-ended output
1 single-ended input, no output
1 balanced input, 1 balanced output
1 balanced input, no output
1 balanced input, 1 single-ended output
2 single-ended inputs, 1 single-ended output
2 single-ended inputs, 2 single-ended outputs
n single-ended inputs, no outputs
n single-ended inputs, m single-ended outputs
n balanced inputs, no outputs
n balanced inputs, m balanced outputs
Currently not supported
tool, it narrows down the selectable
GUI reference
Offset Embed softtool
DUT types and
ISD only
⃞
⃞
⃞
⃞
☑
☑
☑
☑
☑
☑
☑
cou-
655