R&S ZNB Series User Manual page 523

®
R&S ZNB/ZNBT
Take OSM / Take All OSM and Through
"Take OSM" starts a calibration sweep for the related port. "Take All OSM and
Through" initiates a series of calibration sweeps; the R&S ZNB/ZNBT acquires a full
set of one-port and two-port data. The latter is required for the transmission normaliza-
tions and for a "One Path Two Ports" calibration; see
types and characterization data"
Remote command:
[SENSe<Ch>:]CORRection:COLLect:AUTO
[SENSe<Ch>:]CORRection:COLLect:AUTO:PORTs
[SENSe:]CORRection:COLLect:AUTO:PORTs:CONNection?
Next
Proceeds to
R&S ZNB/ZNBT has acquired characterization data for a single port.
Step 2: Save Characterization Data
Saves the characterization data to the calibration unit.
Figure 5-43: Save Characterization Data
Save File to SD Card
For all calibration units, characterization data can be saved to the calibration unit's
internal flash memory. For some calibration units (e.g. the new models R&S ZN-Z5x
and R&S ZN-Z15x), they can also be saved to an SD card inserted at the calibration
unit. Activate this checkbox to save the characterization data to the SD card.
Tip: If the characterized calibration unit does not have an SD card slot, the checkbox is
hidden. If the calibration unit has an SD card slot but the SD card is not accessible, the
checkbox is grayed out.
User Manual 1173.9163.02 ─ 62
on page 185.
Step 2: Save Characterization Data
GUI reference
"Dependency between calibration
. Next is available when the
Cal softtool
523