R&S ZNB Series User Manual page 445

®
R&S ZNB/ZNBT
Sweep All Channels/Sweeps
If you select "Sweep All Channels",
of the active recall set.
For the DEFAULT
channel-specific and can be defined in the table below the separator line. The
"Sweeps" column reflects the
"Sweeps" setting above the separator line is unused and disabled.
For remote languages other than DEFAULT, the "Sweeps" setting above the separator
line defines the common number of sweeps that are executed on each channel in sin-
gle sweep mode. The table below the separator line is unused and disabled.
Tip: In remote control, it is possible to retrieve the results acquired in any of the
sweeps within a single sweep group.
Remote command:
INITiate[:IMMediate]:ALL
INITiate<Ch>[:IMMediate]:SCOPe ALL
[SENSe<Ch>:]SWEep:COUNt
Sweep Active Channel/Sweeps (table)
If you select "Sweep Active Channel", then in single sweep mode
restarts the sweep in the active channel.
The "Sweeps" column reflects the
Remote command:
INITiate<Ch>[:IMMediate]:SCOPe
[SENSe<Ch>:]SWEep:COUNt
5.11 Cal softtool
The "Cal" softtool provides all functions related to system error calibration, scalar
power calibration, and "SMARTerCal".
Access: Channel – [Cal]
User Manual 1173.9163.02 ─ 62
Restart Sweep
Remote Language, the number of sweeps in single sweep mode is
Sweeps settings of the individual channels. The
Sweeps
restarts the sweep in all channels
settings of the individual channels.
SINGle
GUI reference
Cal softtool
Restart Sweep only
445