R&S ZNB Series User Manual page 66

®
R&S ZNB/ZNBT
3.3.5 Handling diagrams, traces, and markers
The analyzer displays measurement results as traces in rectangular diagrams. Markers
are used to read specific numerical values and to search for points or regions on a
trace. The following section presents some of the graphical tools the R&S ZNB/ZNBT
provides for trace and marker handling.
For further reference
Refer to
channels, and screen elements.
3.3.5.1 Adding new traces and diagrams
A new trace is required if you want to measure and display an additional quantity.
Typical scenario: The transmission coefficient S
ter 3.4.1, "Transmission S-parameter
display the reflection coefficient S
To create a trace:
1. Drag the "Trc+" icon from the toolbar into a diagram.
The diagram changes its color scheme and contents as shown below.
2. Select the adequate drop position, depending on whether you want to display the
new trace in the existing diagram, or whether you want to add a new diagram. The
highlighted area indicates the target diagram.
User Manual 1173.9163.02 ─ 62
Chapter 4, "Concepts and features", on page 87 to learn more about traces,
is measured as described in
21
measurement", on page 78. A trace is added to
for comparison.
11
Getting started
Operating the instrument
Chap-
66