R&S ZNB Series User Manual page 333

®
R&S ZNB/ZNBT
Remote command:
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM[:STATe]
Zoom Reset
If a graphical zoom
zoom area.
Remote command:
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM[:STATe]
Overview On
If a graphical zoom
this button toggles the overview for this diagram.
The overview appears in the upper part of the diagram and shows the original diagram
and the zoom area. You can move the zoomed part of the trace by moving the zoom
area or use the numerical input fields "Max", "Min", "Start", "Stop" to do so.
Remote command:
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM[:STATe]
Max / Min / Start / Stop
Defines the coordinates of the graphical zoom window for the active diagram. "Max"
and "Min" define the response axis range, "Start" and "Stop" define the stimulus axis
range.
The input fields are only enabled if a zoom area was selected before.
Remote command:
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM:BOTTom
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM:STARt
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM:STOP
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM:TOP
5.5 Trace Config softtool
The "Trace Config" softtool provides functions for managing traces.
Access: Trace – [Trace Config]
5.5.1 Traces tab
Provides functions to handle traces and diagram areas, and assign traces to channels.
Related information
Refer to the following sections:
●
Chapter 4.1.3, "Traces, channels and
●
Chapter 3.3.5, "Handling diagrams, traces, and
User Manual 1173.9163.02 ─ 62
has been applied to the current diagram, this action resets the
has been applied to the active diagram (and has not been reset,
diagrams",
GUI reference
Trace Config softtool
on page 88
markers", on page 66
333