R&S ZNB Series User Manual page 622

®
R&S ZNB/ZNBT
Background information
Refer to the following sections.
●
Chapter 4.6, "Offset parameters and
●
Chapter 4.6.1.2, "Definition of loss
●
Chapter 4.6.1.4, "Auto Length and
●
Chapter 4.6.1.5, "Fixture
Overview
See
Port
Physical test port of the analyzer. You can define independent loss parameters for all
ports.
Remote command:
The <PhyPt> numeric suffix in the [SENSe<Ch>:]CORRection:... commands
identifies the physical port.
Loss at DC / Loss at 1st Freq / 1st Freq for Loss
See
Freq / 2nd Freq for Loss"
Auto Length and Loss
Determines the length offset and one-way loss parameters for the receive port of the
active trace. See
Use
Note:
●
If "Auto Length and Loss" is used with a line connected to a test port, the end of the
line should be left open.
●
To calculate the electrical length offset and loss of port i, you have to select a trace
that uses port i as one of its receive ports. It is not relevant for the "Auto Length
and Loss" function which
User Manual 1173.9163.02 ─ 62
"Overview" on page 616.
"Loss at DC / Loss at 1st Freq / 1st Freq for Loss / Use 2nd Freq / Loss at 2nd
on page 607.
Chapter 4.6.1.4, "Auto Length and
Evaluation Range... to limit the frequency range for the calculation.
de-/embedding",
parameters",
Loss", on page 205
Compensation", on page 206
Port is selected.
GUI reference
Offset Embed softtool
on page 202
on page 203
Loss", on page 205.
622