R&S ZNB Series User Manual page 429

®
R&S ZNB/ZNBT
Remote command:
[SENSe<Ch>:]SWEep:TYPE POWer
CW Mode
"CW Mode" sweeps, like
ulus power, which can be specified in the "Stimulus" settings (see
ulus
The measurement is triggered according to the current trigger settings (see
ter 5.10.3, "Trigger
surement of a measurement point. The time interval between two consecutive mea-
surements depends on the trigger settings and the sweep parameters (especially the
number of points). Any trigger mode is allowed.
A "CW Mode" sweep corresponds to the analysis of a signal over the time with a time
scale and resolution that is determined by the trigger events. In a Cartesian diagram,
the measurement result is displayed as a trace over a linear time scale (like, e.g., in an
oscilloscope). The diagram is similar to the "Time" diagram. The following example
shows a "CW Mode" sweep with a DUT that does not markedly change its transmis-
sion characteristics over the time.
Tip: Sweep time
The time interval between two consecutive trigger pulses must not be smaller than the
minimum measurement time per measurement point. See
on page 424.
Remote command:
[SENSe<Ch>:]SWEep:TYPE POINt
User Manual 1173.9163.02 ─ 62
Time
tab", on page 414).
tab", on page 437). Each trigger event triggers the first partial mea-
sweeps, are performed at constant frequency and stim-
GUI reference
Sweep Softtool
Chapter 5.8.1, "Stim-
Chap-
"Sweep Time / Auto"
429