R&S ZNB Series User Manual page 615

®
R&S ZNB/ZNBT
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:DIFFerential:
EMBedding<LogPt>[:STATe]
File Name 1
The ellipsis button in the "File Name 1" column is enabled if a 2-port data
selected.
When loading the touchstone file (*.s2p), the analyzer by default assumes odd ports
left (VNA side), even ports right (DUT side). However, it is also possible to "Swap
Gates", instructing the analyzer to reinterpret the loaded S-parameters (e.g. S
S ).
21
Note: The loaded S-parameter traces are stored in the active recall set. Persisted
recall sets contain the full embedding and deembedding data so that they can be trans-
ferred to other instruments.
Remote command:
MMEMory:LOAD:VNETworks<Ch>:DIFFerential:EMBedding<LogPt>
5.13.2 Offset tab
Defines length offset parameters for each port.
Use the complementary dock widget to activate or deactivate length/loss compensation
for selected ports (see
The marker function
Background information
Refer to the following sections.
●
Chapter 4.6, "Offset parameters and
●
Chapter 4.6.1.1, "Definition of offset
●
Chapter 4.6.1.3, "Auto
●
Chapter 4.6.1.6, "Application and effect of offset
●
Chapter 4.6.1.7, "Offset parameters for balanced
●
Chapter 4.6.1.5, "Fixture
User Manual 1173.9163.02 ─ 62
Chapter 5.13.1.2, "Offset
Zero Delay at Marker function overwrites the offset parameters.
de-/embedding",
parameters",
Length", on page 204
Compensation",
Offset Embed softtool
panel", on page 606).
on page 202
on page 203
parameters", on page 207
ports", on page 208
on page 206
GUI reference
Network is
-->
12
615