R&S ZNB Series User Manual page 442

®
R&S ZNB/ZNBT
5.10.4.1 Controls on the Sweep Control tab
Continuous / Single
Activate either continuous (default) or single sweep mode.
●
In "Continuous" sweep mode, the analyzer measures the related channel (or chan-
nels) continuously, repeating the current sweep over and over.
●
In "Single" sweep mode, the measurement is stopped after the configured number
of Sweeps.
Restart Sweep
For the DEFAULT
Use
for all channels.
For remote languages other than DEFAULT, this setting applies to all channels.
Remote command:
INITiate<Ch>:CONTinuous
See also:
CONFigure:CHANnel<Ch>:MEASure[:STATe]
CONFigure:CHANnel:MEASure:ALL[:STATe]
Sweeps
Defines the number of sweeps to be performed in "Single" sweep mode (see
ous / Single"
This setting applies to the active channel. In "Continuous" sweep mode, it is not availa-
ble (grayed out).
For remote languages
define the number of sweeps in the
Remote command:
[SENSe<Ch>:]SWEep:COUNt
[SENSe:]SWEep:COUNt:ALL
User Manual 1173.9163.02 ─ 62
initiates a new measurement cycle.
Remote Language, this setting applies to the active channel only.
All Channels Continuous/All Channels on Hold
on page 442).
other than DEFAULT, the "Sweeps" setting is disabled. You can
to select a common sweep mode
Restart Manager dialog.
GUI reference
Sweep Softtool
"Continu-
442