Table Of Contents - R&S ZNB Series User Manual

®
R&S ZNB/ZNBT
Calibration Type Standards
TRM Reflect (equal at
both ports), Match,
(n-port)
Through (between
all port pairs)
TRL Reflect (at both
ports),
(n-port)
Through, Line1,
other Lines
(optional), combina-
tion with TRM
(optional)
TNA Through, Attenua-
tion, Symmetric
(n-port)
network
1)
Or any other 3 known one-port standards. To be used in a guided calibration, the known standards must be declared to be Open,
Short, and Match irrespective of their properties.
2) Or any other known two-port standard. To be used in a guided calibration, the known standard must be declared to be Through,
irrespective of its properties.
The calibration type must be selected in accordance with the test setup. Select the cali-
bration type for which you can obtain or design the most accurate standards and for
which you can measure the required parameters with best accuracy.
●
●
●
●
●
●
●
●
●
●
●
●
User Manual 1173.9163.02 ─ 62
Parameters
All
All
All
Normalization (reflection,
Reflection OSM calibration....................................................................................166
One Path Two Ports Calibration............................................................................166
TOSM and UOSM calibration................................................................................167
Adapter removal....................................................................................................168
TOM calibration.....................................................................................................170
TSM calibration..................................................................................................... 170
TRM calibration..................................................................................................... 170
TRL calibration...................................................................................................... 170
TNA calibration......................................................................................................173
Full n-Port calibration with reduced number of Through
Complementary isolation
Error Terms
Reflection tracking,
Source match,
Directivity,
Load match,
Transmission track-
ing
Reflection tracking,
Source match,
Directivity,
Load match,
Transmission track-
ing
Reflection tracking,
Source match,
Directivity,
Load match,
Transmission track-
ing
transmission)................................................................ 166
measurement................................................................174
Concepts and features
General Accuracy Application
High Reflection and
transmission mea-
surements, espe-
cially in test fixtures.
High, high directiv- Reflection and
ity transmission mea-
surements, espe-
cially for planar cir-
cuits. Limited band-
width.
High, lowest Reflection and
requirements on transmission mea-
standards surements, espe-
cially for planar cir-
cuits.
connections................... 173
Calibration
165