R&S ZNB Series User Manual page 632

®
R&S ZNB/ZNBT
Load File
Load DUT + test fixture data from file
Remote command:
CALCulate:FMODel:EZD:DUT:MEASure:FILename
CALCulate:FMODel:EZD:DUT:MEASure:FILename:CLEar
CALCulate:FMODel:ISD:DUT:MEASure:FILename
CALCulate:FMODel:ISD:DUT:MEASure:FILename:CLEar
CALCulate:FMODel:SFD:DUT:MEASure:FILename
CALCulate:FMODel:SFD:DUT:MEASure:FILename:CLEar
Measure
Starts the measurement of DUT + test fixture at the
The display area shows all the S parameter measurements being made. The resulting
Touchstone file is written to C:\Users\Public\Documents\Rohde-Schwarz\Vna\Embed-
ding.
Remote command:
CALCulate:FMODel:EZD:DUT:MEASure
CALCulate:FMODel:ISD:DUT:MEASure
CALCulate:FMODel:SFD:DUT:MEASure
Active
Before starting to Measure, use these checkboxes to indicate the physical ports to
which DUT + test fixture are connected. For single-ended deembedding, 2 ports must
be active, for balanced deembedding 4 ports.
Remote command:
CALCulate:FMODel:EZD<Ph_pt>:DUT[:STATe]
CALCulate:FMODel:ISD<Ph_pt>:DUT[:STATe]
CALCulate:FMODel:SFD<Ph_pt>:DUT[:STATe]
5.13.5.4 Save Fixture Model
This section allows you to run the selected deembedding tool to generate the Touch-
stone files for fixture deembedding (and the Touchstone file of the de-embedded DUT).
User Manual 1173.9163.02 ─ 62
GUI reference
Offset Embed softtool
Active ports.
632