R&S ZNB Series User Manual page 881

®
R&S ZNB/ZNBT
Parameters:
<Boolean>
Options:
Manual operation:
CALCulate<Chn>:EYE:STIMulus:LOWPass <Boolean>
Enables/disables a single pole low pass filter in the binary signal generator simulation
of the related eye diagram measurement.
The low-pass is defined using its rise time (see
RTIMe:DATA
INPut:RTIMe:THReshold
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Suffix:
<Chn>
Parameters:
<Boolean>
Options:
Manual operation:
CALCulate<Chn>:EYE:STIMulus:SCRambler <Boolean>
Enables/disables the scrambler in the bit stream simulation of the related eye diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Suffix:
<Chn>
Parameters:
<Boolean>
Options:
Manual operation:
CALCulate<Chn>:EYE:VIEW <EyeView>
Allows to shorten the calculation chain of the related eye diagram without deactivating
the building blocks at the tail end.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Suffix:
<Chn>
User Manual 1173.9163.02 ─ 62
*RST: OFF
R&S ZNB/ZNBT-K20
See "Encoder"
on page 865) and rise time definition (see
on page 865).
.
Channel number used to identify the active trace
*RST: OFF
R&S ZNB/ZNBT-K20
See "Low Pass"
.
Channel number used to identify the active trace
*RST: OFF
R&S ZNB/ZNBT-K20
See "Scrambler"
.
Channel number used to identify the active trace
SCPI command reference
on page 696
CALCulate<Chn>:EYE:INPut:
CALCulate<Chn>:EYE:
on page 694
on page 696
Command reference
881