R&S ZNB Series User Manual page 631

®
R&S ZNB/ZNBT
Remote command:
CALCulate:FMODel:ISD:COUPon:MEASure:FILename
CALCulate:FMODel:ISD:COUPon:MEASure:FILename:CLEar
CALCulate:FMODel:ISD:COUPon:MEASure:OPEN:FILename
CALCulate:FMODel:ISD:COUPon:MEASure:SHORt:FILename
CALCulate:FMODel:SFD:COUPon:MEASure:FILename
CALCulate:FMODel:SFD:COUPon:MEASure:FILename:CLEar
CALCulate:FMODel:EZD:COUPon:MEASure:FILename
CALCulate:FMODel:EZD:DUT:MEASure:FILename:CLEar
Active
Before starting to
physical ports to which it is connected.
Table 5-6: Allowed numbers of active ports
Single-ended
Balanced
Remote command:
CALCulate:FMODel:ISD<Ph_pt>:COUPon[:STATe]
CALCulate:FMODel:SFD<Ph_pt>:COUPon[:STATe]
CALCulate:FMODel:EZD<Ph_pt>:COUPon[:STATe]
5.13.5.3 Measure DUT + Test Fixture
The "Measure DUT + Test Fixture" section allows you to measure the whole structure,
i.e. the DUT with the test fixture.
For EZD this section is only available if
"Advanced Settings".
User Manual 1173.9163.02 ─ 62
measure the test coupon, use these checkboxes to indicate the
"Sym 2x Thru"
2
2 or 4
impedance correction
"1x Open, 1x Short" other
1 or 2 1
2 or 4 2
is enabled in the
GUI reference
Offset Embed softtool
631