R&S ZNB Series User Manual page 781

®
R&S ZNB/ZNBT
Background information
Refer to section
The configuration of a new external power meter involves the following steps:
1. Connect the power meter to your R&S ZNB/ZNBT using a LAN (VXI-11), GPIB, or
USB interface.
2. If the power meter is connected via LAN, enable
3. Select
"Known Devices".
4. Select
If the R&S ZNB/ZNBT fails to detect a connected power meter:
► Select
The R&S ZNB/ZNBT can auto-detect the instrument type (driver) and the serial
number of the connected power meter.
To control external devices via GPIB, the pre-installed RS Visa library (visa32.dll)
must be replaced by the NI Visa library.
Known Devices
Table with all power sensors/meters the analyzer detects to be on line (i.e. connected
and switched on). "Scan Instruments" refreshes the table.
Select
User Manual 1173.9163.02 ─ 62
Chapter 4.7.27, "External power
Scan Instruments and wait until the power meter appears in the table of
to add the power meter to the list of
Add Device to define the interface type and address.
to add a power sensor/meter to the table of
GUI reference
meters", on page 265.
LAN Detection
Configured Devices.
Configured Devices.
Setup softtool
781