R&S ZNB Series User Manual page 892

®
R&S ZNB/ZNBT
Options:
Manual operation:
CALCulate:FMODel:DEASsistant:IMPCorrect <Boolean>
Parameters:
<Boolean>
Manual operation:
CALCulate:FMODel:DEASsistant:PRESet
Resets the DUT and fixture settings of the deembedding assistant to their respective
defaults.
Note that a *RST does not affect these settings.
Usage:
Options:
Manual operation:
CALCulate:FMODel:DEASsistant:RUN
Runs the selected demmbedding (CALCulate:FMODel:DEASsistant:TOOL) tool
and applies the calculated fixture deembedding to the ports selected using
CALCulate:FMODel:DEASsistant:DUT:PORT.
Usage:
Options:
Manual operation:
CALCulate:FMODel:DEASsistant:SAMCoupon <Boolean>
For the deembedding assistant, this command defines whether only the left coupon
model is measured or loaded from file.
User Manual 1173.9163.02 ─ 62
BALanced
Balanced; for balanced lead-ins/outs
COUPled
Coupled ports; for lead-ins/outs with more than two logical ports
UNCoupled
Coupled ports; for lead-ins/outs with more than two physical
ports
R&S ZNB/ZNBT-K220 | R&S ZNB/ZNBT-K230 | R&S ZNB/
ZNBT-K210
See "Left: Model A / Right: Model A|B"
See "Measure / Apply section"
Event
R&S ZNB/ZNBT-K220 | R&S ZNB/ZNBT-K230 | R&S ZNB/
ZNBT-K210
See "DUT" on page 655
Event
R&S ZNB/ZNBT-K220 | R&S ZNB/ZNBT-K230 | R&S ZNB/
ZNBT-K210
See "Measure / Apply section"
Command reference
SCPI command reference
on page 656
on page 660
on page 660
892