R&S ZNB Series User Manual page 598

®
R&S ZNB/ZNBT
Depending on your selection, the wizard either closes without calibration or
launches one of the mixer measurement-specific SMARTerCal wizards (see
ter 5.12.6.4, "SMARTerCal (Cal Unit) wizard for mixer
Chapter 5.12.6.5, "SMARTerCal (Manual) wizard for mixer
5.12.6.3 (Mixer) Setup dialog
The "(Mixer) Setup" dialog is an example of a
up one or more channels for mixer measurements.
Access: Channel – [Channel Config] > "Mixer Mode" > "Mixer Meas..."
Background information
Refer to the following sections:
●
Chapter 4.7.4.2, "Scalar mixer
●
"Two-stage mixer measurements"
The upper part the "Define Mixer Meas" dialog shows a diagram with the RF and LO
signals, the mixing product (IF), and the current frequency and power ranges for all sig-
nals. The diagram is adjusted according to the "2nd Mixer" selection; see
mixer measurements"
In the lower part of the dialog, the frequency and power settings are performed.
User Manual 1173.9163.02 ─ 62
measurements",
on page 239
on page 239.
Channel Config softtool
mode", on page 602 and
mode",
Multi-channel setup dialog. It lets you set
on page 238
GUI reference
Chap-
on page 603).
"Two-stage
598