R&S ZNB Series User Manual page 543

®
R&S ZNB/ZNBT
Imported cal kits with uncertainties are preserved and added to the
combo-box. There and in the
flag.
Start
Proceeds to
played:
Step 3: Calibration
In step 3, the calibration is performed. The procedure is the same as for regular cali-
brations of the selected type (see
On "Apply", the raw calibration data are transferred to METAS VNA Tools, which take
over the calculation of measurement results and uncertainties:
enabled automatically.
In parallel to the "METAS Calibration", a regular VNA calibration without uncertainties
is created. This calibration can be activated if "METAS Cal Active" is unchecked.
5.11.5.3 METAS Verification dialog
This dialog allows you to set up and perform a
For background information see
Access: Channel – [Cal] > "METAS Cal" > "Start Verification"
Step 1: Verification Kit
Allows you to select the verification kit to be used. All other settings are taken from the
active
User Manual 1173.9163.02 ─ 62
Step 3: Calibration. If the configuration is not plausible, a warning is dis-
METAS calibration and cannot be changed.
Calibration Kits dialog, they appear with an "Uncertainty"
"Step 3: Calibration"
Verification
"Verification" on page 249.
GUI reference
Cal softtool
Cal Kit selection
on page 468).
METAS Cal Active
of a METAS Calibration.
is
543