R&S ZNB Series User Manual page 780

®
R&S ZNB/ZNBT
5.18.4.1 Controls on the External Devices tab
The buttons in the "External Devices" panel open the following dialogs:
●
"Power Meters...", see
on page 780
●
"Power Meter Config...", see
log",
This button is active only if at least one external power meter is online (physically
connected, switched on, ready to be used).
●
"Generators...", see
●
"Inline Cal Systems", see
on page 789
Switch matrices can be configured on the "External Ports" tab, see
"External Matrices
Connections
Remote control via GPIB
To control external devices via GPIB, you have to use an
IEEE
Log Errors
Enables the transfer of error messages for external devices (e.g. connection errors) to
the error log. The error log appears in the "Info" dialog; see
log",
Remote command:
n/a
5.18.4.2 External Power Meters dialog
The "External Power Meters" dialog configures external power meters so that they can
be used for measurements and power calibrations.
Access: System – [Setup] > "External Devices" > "Power Meters..."
User Manual 1173.9163.02 ─ 62
Chapter 5.18.4.2, "External Power Meters
on page 784
Chapter 5.18.4.4, "External Generators
dialog", on page 791 and
dialog", on page 796.
adapter", on page 265.
on page 766.
Chapter 5.18.4.3, "External Power Meter Config dia-
Chapter 5.18.4.5, "Inline Calibration Systems
Chapter 5.18.5.5, "Switch Matrix RF
GUI reference
Setup softtool
dialog",
dialog", on page 785
dialog",
Chapter 5.18.5.3,
Chapter 4.7.26, "USB-to-IEC/
Chapter 5.18.1.3, "Info dia-
780