R&S ZNB Series User Manual page 396

®
R&S ZNB/ZNBT
Remote command:
CALCulate<Chn>:MARKer<Mk>:TYPE
CALCulate<Chn>:MARKer<Mk>:REFerence:TYPE
Marker Info
Displays the marker coordinates above the marker symbol.
Remote command:
n/a
Ref Mkr -> Mkr
Places the reference marker to the position of the active marker. "Ref. Mkr -> Mkr" is
not active if the active marker is a reference marker.
Remote command:
n/a
Export Markers
Calls up a "Save As"... dialog to store the current marker values to a marker file.
The analyzer uses a simple ASCII format to export marker values. By default, the
marker file extension is *.txt. The file contains all traces in the active recall set
together with their names and measured quantities. Below each trace, the file shows a
list of all markers with their names, stimulus and response values.
The following example of a marker file describes a recall set with two traces, "Trc1"
and its memory trace "Mem2[Trc1]". "Trc1" has a reference marker "R" and three nor-
mal markers "M1, M2, M3" assigned, the memory trace has no markers.
Remote command:
MMEMory:STORe:MARKer
Decimal Places...
Opens the "User Interface" tab of the "System Config" dialog, which allows to define
the (maximum) number of decimal digits for different units. See
on page 755.
5.7.3 Marker Search tab
Provides "Marker Search" functions that move the active marker to a (local) maximum
or minimum of the active trace.
The search operation can be restricted to a configurable range of stimulus values
("Search Range..."). By default, the search range is equal to the entire sweep range.
If necessary, the active marker is enabled to indicate the search result.
User Manual 1173.9163.02 ─ 62
GUI reference
Marker softtool
"User Interface tab"
396