R&S ZNB Series User Manual page 674

®
R&S ZNB/ZNBT
5.14.3 Print tab
The buttons on the "Print" tab allow you to send the diagrams of the active setup to an
external printer, to a file or to the clipboard. Content and layout can be defined in the
Printer Setup
Print
Prints the diagrams using the current content, printer and page settings (see
ter 5.14.4, "Printer Setup
Remote command:
The HCOPy... commands provide the printer settings; see
HCOPy[:IMMediate]
Print...
Opens a dialog that allows to define the content, printer and page settings (see
ter 5.14.4, "Printer Setup
To File...
Opens the "Save Image" dialog that allows you to select a graphics file type
(*.bmp, *.jpg | *.jpeg, *.pdf, *.png, *.svg) and to save diagram con-
tent to a file of this type (see also
Note that the diagram content to be saved can be configured in the
"Print Charts" group of the "Printer Setup" dialog. E.g., if you select "All diagrams on
their own page" there, then only the content of the active diagram is saved to file. If you
select "No diagram at all", then "To File..." is disabled.
Remote command:
HCOPy:DESTination
To Clipboard
Copies diagram content to the clipboard, from where you can paste it into another
application.
Note that the diagram content to be copied can be configured in the
"Print Charts" group of the "Printer Setup" dialog. E.g., if you select "All diagrams on
their own page" there, then only the content of the active diagram is copied to clip-
board. If you select "No diagram at all", then "To Clipboard" is disabled.
User Manual 1173.9163.02 ─ 62
dialog.
dialog", on page 675).
initiates printing.
dialog", on page 675).
"Save Dialog"
HCOPy commands.
on page 115).
Content tab
Content tab
GUI reference
File softtool
Chap-
Chap-
>
>
674