R&S ZNB Series User Manual page 906

®
R&S ZNB/ZNBT
CALCulate:FMODel:EZD:IMPedance <Boolean>
Switches the impedance correction of the EZD tool ON or OFF. Its reference impe-
dance and bandwidth limit parameters can be set using
IMPedance:REFerence
respectively.
This is a global setting.
Parameters:
<Boolean>
Options:
Manual operation:
CALCulate:FMODel:EZD:IMPedance:BWIDlimit <Value>
Defines the "Bandwidth Limit" parameter of the EZD tool's impedance correction (see
CALCulate:FMODel:EZD:IMPedance.
Parameters:
<Value>
Options:
Manual operation:
CALCulate:FMODel:EZD:IMPedance:REFerence <Value>
Defines the reference impedance for the impedance correction of the EZD tool (see
CALCulate:FMODel:EZD:IMPedance).
Parameters:
<Value>
Options:
Manual operation:
CALCulate:FMODel:EZD:PORT:ORDer <PortOrder>
Tells the EZD tool about the port ordering of the test fixture.
Parameters:
<PortOrder>
Options:
Manual operation:
User Manual 1173.9163.02 ─ 62
and CALCulate:FMODel:EZD:IMPedance:BWIDlimit,
ON (1) or OFF (0)
R&S ZNB/ZNBT-K210
See "Use Impedance Correction"
Default unit: Hz
R&S ZNB/ZNBT-K210
See "Impedance Correction Settings"
Default unit: Ohm
R&S ZNB/ZNBT-K210
See "Impedance Correction Settings"
ODD | NON
ODD: odd ports are on the left and even ports are on the right
NON: ports 1 to N are on the left and ports N+1 to 2·N are on
the right
R&S ZNB/ZNBT-K210
See "Port Order" on page 640
Command reference
SCPI command reference
CALCulate:FMODel:EZD:
on page 629
on page 640
on page 640
906