R&S ZNB Series User Manual page 909

®
R&S ZNB/ZNBT
Manual operation:
CALCulate:FMODel:ISD:COUPon:MEASure
For a fixture modeling with the ISD tool and coupon types SYMMetric2x | OPEN1x |
SHORt1x (see CALCulate:FMODel:ISD:COUPon:TYPE), this command starts the
measurement of the coupon at the active ports (see
ISD<Ph_pt>:COUPon[:STATe]).
Example:
Usage:
Manual operation:
CALCulate:FMODel:ISD:COUPon:MEASure:FILename <String>
For a fixture modeling with the ISD tool and coupon types SYMMetric2x | OPEN1x |
SHORt1x (see CALCulate:FMODel:ISD:COUPon:TYPE), this command loads the
coupon properties from a Touchstone file.
Parameters:
<String>
Manual operation:
CALCulate:FMODel:ISD:COUPon:MEASure:FILename:CLEar
Invalidates the file path previously set using
MEASure:FILename,
FILename, or CALCulate:FMODel:ISD:COUPon:MEASure:SHORt:FILename.
Usage:
Manual operation:
CALCulate:FMODel:ISD:COUPon:MEASure:OPEN
For a fixture modeling with the ISD tool and coupon type OPSHort1x (see
CALCulate:FMODel:ISD:COUPon:TYPE), this command starts the measurement of
the Open coupon at the active ports (see
COUPon[:STATe]).
Usage:
User Manual 1173.9163.02 ─ 62
RESonant
The 2x thru test coupon will be split and used directly for deem-
bedding (parameter value 3).
This option may be more accurate when the fixture and 2x Thru
have the same impedance at every location
See "Test Coupons > Insertion Loss"
See Chapter 8.2.8, "Fixture
Event
See "Measure / Measure Open / Measure Short"
Path to the Touchstone file, either absolute or relative to the
selected working directory (CALCulate:FMODel:DIRectory).
See "Load File / 1x Open Preset / 1x Short Preset"
CALCulate:FMODel:ISD:DUT:
CALCulate:FMODel:ISD:COUPon:MEASure:OPEN:
Event
See "Load File / 1x Open Preset / 1x Short Preset"
CALCulate:FMODel:ISD<Ph_pt>:
Event
Command reference
SCPI command reference
on page 636
CALCulate:FMODel:
modeling", on page 1527
on page 630
on page 630
on page 630
909