R&S ZNB Series User Manual page 914

®
R&S ZNB/ZNBT
CALCulate:FMODel:ISD:PORT:ORDer <PortOrder>
Defines how the ISD tool shall interpret the DUT + Fixture data (see
FMODel:ISD:DUT:MEASure):
●
NON: ports 1 to N are on the left and ports N+1 to 2*N are on the right
●
ODD: ports 1, 3, 5, etc. are on the left and ports 2, 4, 6, etc. are on the right.
●
ALL: use this to tell the ISD tool that all ports are on the left (i.e. assumed to be
coupled)
Corresponds to the port_order batch mode parameter of the ISD tool.
Parameters:
<PortOrder>
Manual operation:
CALCulate:FMODel:ISD:PORT:SKIP <String>
Tells the ISD tool which ports (in the measured DUT + Test Fixture file) shall be skip-
ped when the tool is run.
Equivalent to using the ports_to_skip batch mode parameter of the ISD tool with a
list of (positive) port numbers.
Parameters:
<String>
Manual operation:
CALCulate:FMODel:ISD:PORT:SKIP:LEFT
CALCulate:FMODel:ISD:PORT:SKIP:NONE
CALCulate:FMODel:ISD:PORT:SKIP:RIGHt
Tells the ISD tool which ports (in the measured DUT + Test Fixture file) shall be skip-
ped when the tool is run.
●
...:LEFT: skip the ports on the left (according to the port order specified using
CALCulate:FMODel:ISD:PORT:ORDer)
●
...:NONE: do not skip any ports
●
...:RIGHt: skip the ports on the right (according to the port order specified using
CALCulate:FMODel:ISD<Ph_pt>:PORT:ORDer)
Equivalent to setting the ports_to_skip batch mode parameter of the ISD tool to -1,
0 or -2, respectively.
Use
skipped.
Usage:
Manual operation:
User Manual 1173.9163.02 ─ 62
ODD | NON | ALL
See
The port numbers, separated by blanks (e.g. '1 3 4').
See
CALCulate:FMODel:ISD:PORT:SKIP
Event
See
"Port Sequence" on page 636
"Ports to Skip (manual)"
to define an arbitrary set of ports to be
"Ports to Skip" on page 637
Command reference
SCPI command reference
CALCulate:
on page 637
914