R&S ZNB Series User Manual page 50

®
R&S ZNB/ZNBT
13
Figure 3-5: R&S ZNBT rear view
Table 3-4: Rear panel connectors available on all instruments
Index
1
2
3
4
5
6
7
8
9
User Manual 1173.9163.02 ─ 62
1
2
3 4
15
Label Description
(Power Power on/off switch, see
I/O) on page 28
(Fuse Fuse holder, see
holder)
LAN RJ-45 connector to integrate the instrument to a Local Area Network, primarily for
remote control purposes; see
on page 35.
See also Chapter 12.3.2, "LAN
USB / Two additional type A USB 3.0 host connectors; similar functionality as the type A
USB Host USB host connectors on the front panel (see
Monitor External monitor connector (DisplayPort); see
(Display- tor", on page 32.
Port)
USB Type B USB 3.0 device (slave) connector for remote control of the instrument (see
Device Chapter 3.1.11.6, "Connecting a USB cable for remote
Monitor External monitor connector (DVI-D); see
(DVI-D) on page 32.
USER 25-pin D-Sub connector used as an input and output for low-voltage (3.3 V) TTL
PORT
control signals
See Chapter 12.3.1.1, "User
EXT TRIG Two BNC connectors for 5 V TTL external trigger signals
IN / EXT
See Chapter 5.10.3, "Trigger
TRIG
OUT
5 6 7
9 10
8
Chapter 3.1.7, "Switching the instrument on and
Chapter 11.1, "Replacing fuses",
Chapter 3.1.12.1, "Assigning an IP
interface", on page 1540.
"USB Connectors"
Chapter 3.1.11.1, "Connecting a
Port", on page 1538.
tab", on page 437.
Getting started
Instrument tour
16
17
11
12
14
off",
on page 1535
address",
on page 46).
Chapter 3.1.11.1, "Connecting a moni-
control", on page 34)
monitor",
50