R&S ZNB Series User Manual page 684

®
R&S ZNB/ZNBT
The "TDR Setup" contains the following sections/controls:
●
"TDR Wizard..."
Opens the "TDR Wizard" (see
●
"Topology"
Opens the "Balanced Ports" dialog that allows to configure the logical DUT ports
(see
●
"Stimulus..."
Opens the
sweep whose results are then used for the time domain transformation
●
"Calibration"
The "Calibration" section provides easy access to (basic) manual and automatic
calibration functions (see
●
"Stimulus"
The "Stimulus" section provides quick access to settings that are also available in
the
Harmonic Grid
Stimulus Settings" dialog.
5.16.2.2 TDR Wizard
With the "TDR Wizard", you can quickly set up and calibrate a TDR measurement. It
comprises the following steps:
●
Step 1: Port Topology
●
Step 2: Stimulus Settings
Access: System – [Applic] > "TDR" > "TDR Setup" > "TDR Wizard..."
User Manual 1173.9163.02 ─ 62
Chapter 5.2.1.3, "Balanced Ports
TDR Stimulus Settings dialog
Chapter 5.11.1, "Start Cal
TDR Stimulus Settings
mode, which is activated automatically when opening the "TDR
Chapter 5.16.2.2, "TDR
dialog", on page 289)
that allows to configure the frequency
dialog. These settings are only available in
GUI reference
Applic softtool
Wizard", on page 684)
tab", on page 446)
Automatic
684