R&S ZNB Series User Manual page 415

®
R&S ZNB/ZNBT
For a
Note: For segmented frequency sweeps the start and stop frequencies and the num-
ber of sweep points are defined per segment. See
dialog",
Remote command:
[SENSe<Ch>:]FREQuency:STARt
[SENSe<Ch>:]FREQuency:STOP
[SENSe<Ch>:]FREQuency:CENTer
[SENSe<Ch>:]FREQuency:SPAN
SYSTem:FREQuency?
Number of Points
Sets the total number of measurement points for
This value can also be set on the "Sweep Params" tab of the "Sweep"softtool (see
"Number of Points"
Remote command:
[SENSe<Ch>:]SWEep:POINts
Stop Time
Defines the sweep range for
Remote command:
[SENSe<Ch>:]SWEep:TIME
CW Frequency
Sets the fixed frequency for Power,
The "CW Frequency" is also used as the channel base frequency for frequency-con-
verting measurements; see
on page 236.
Remote command:
[SENSe<Ch>:]FREQuency:FIXed
[SENSe<Ch>:]FREQuency[:CW]
SOURce<Ch>:FREQuency<PhyPt>:FIXed
SOURce<Ch>:FREQuency<PhyPt>[:CW]
5.8.2 Power tab
The "Power" tab provides settings related to transmit and receive power. It is also dis-
played on the "Power Bw Avg" softtool.
User Manual 1173.9163.02 ─ 62
Log Freq only "Start Frequency" and "Stop Frequency" can be set.
on page 431.
(query frequency range of the network analyzer)
on page 423).
Chapter 4.7.4, "Frequency conversion
Chapter 5.10.2.2, "Define Segments
CW Mode
Time sweeps.
CW Mode, and
GUI reference
Stimulus softtool
sweeps.
Time sweeps.
measurements",
415