R&S ZNB Series User Manual page 382

®
R&S ZNB/ZNBT
Ripple limits can be defined for cartesian trace formats only and are limited to the trace
format they were configured for. If another format is selected, the ripple limit lines are
hidden and the limit check is temporarily disabled.
Background information
Refer to
5.6.2.1 Controls on the Ripple Test tab
The "Def. Ripple Test..." button opens the "Define Ripple Test" dialog (see
ter 5.6.2.2, "Define Ripple Test
Show Ripple Limits
Shows or hides the ripple limit lines associated with the active trace in a Cartesian dia-
gram area. The vertical positions of the ripple lines are recalculated after each sweep;
only their stimulus range and distance (the ripple limit) are fixed.
Note: Limit line display and limit check are independent of each other: Hiding the limit
line does not switch off the limit check.
Remote command:
CALCulate<Chn>:RIPPle:DISPlay[:STATe]
User Manual 1173.9163.02 ─ 62
Chapter 4.4.1, "Limit check", on page 144.
dialog", on page 384).
GUI reference
Lines softtool
Chap-
382