R&S ZNB Series User Manual page 912

®
R&S ZNB/ZNBT
Manual operation:
CALCulate:FMODel:ISD:DUT:MEASure:FILename:CLEar
Invalidates the file path previously set using
MEASure:FILename.
Usage:
Manual operation:
CALCulate:FMODel:ISD<Ph_pt>:DUT[:STATe] <Boolean>
For a fixture modeling with the ISD tool, this command allows to specify the ports to
which the test fixture is connected.
This has to be defined before measuring DUT + Fixture (using
ISD:DUT:MEASure).
Suffix:
<Ph_pt>
Parameters:
<Boolean>
Example:
Manual operation:
CALCulate:FMODel:ISD:DUT:TYPE <DUTType>
Defines whether the DUT is active or passive.
Corresponds to the active_dut batch mode parameter of the ISD tool.
Parameters:
<DUTType>
Manual operation:
CALCulate:FMODel:ISD:FTIMe:DUT <FltDutAndLeadIns>
If
CALCulate:FMODel:ISD:FTIMe:OVERride
to set the flight time for DUT + Lead-ins manually.
This is equivalent to setting the leadin_dut_time batch mode parameter of the ISD
tool to a numeric value (not auto).
Parameters:
<FltDutAndLeadIns> Default unit: s
Manual operation:
User Manual 1173.9163.02 ─ 62
See "Load File" on page 632
CALCulate:FMODel:ISD:DUT:
Event
See "Load File" on page 632
.
Physical port number
1 (ON, true) if the test fixture is connected to port <Ph_pt>, 0
(OFF, false) otherwise
See Chapter 8.2.8, "Fixture
See "Active" on page 632
PASSive | ACTive
See "DUT Type" on page 637
See "DUT + lead-ins flight time"
Command reference
SCPI command reference
CALCulate:FMODel:
modeling", on page 1527
is set to TRUE, this command allows
on page 636
912