R&S ZNB Series User Manual page 808

®
R&S ZNB/ZNBT
In case the "Remote" softtool is not visible, tap/click on the toucscreen/application win-
dow to restore it.
The softkeys in the remote screen are used to modify or quit the remote state:
●
"Go to Local" switches the instrument to local state.
●
"Display" switches the display on or off.
●
If a remote error message is displayed at the bottom of the remote screen, you can
use "Clear Error Messages" to delete it.
The remaining controls are for future extensions.
Display on and off states
Switching on the display means that the analyzer shows the measurement screen with
the current recall sets, diagram areas and traces without leaving the remote state. In
this operating mode, it is possible to observe the screen while a remote control script is
executed and the control elements on the front panel are still disabled.
User Manual 1173.9163.02 ─ 62
Remote control
Introduction to remote control
808