R&S ZNB Series User Manual page 389

®
R&S ZNB/ZNBT
Radius / Center X / Center Y
Defines the limit circle by its radius and its center on the X-axis and Y-axis.
Remote command:
CALCulate<Chn>:LIMit:CIRCle:DATA
Global Check
See
TTL1 Pass / TTL2 Pass
See
5.6.4 Display Circle tab
The "Display Circle" functionality allows you to limit results in complex trace formats
(Smith, Polar) to a user-defined circle. In particular, while the trace format is complex,
line and circle limit checks are only performed inside the display circle.
Most of the controls on this tab are only active, if the active trace is displayed in a com-
plex format.
Show Border
If enabled, the border of the Display Circle is shown whenever the related trace is dis-
played in complex format.
The border color can be modified by a user-defined color scheme
Range Lines").
Remote command:
CALCulate<Chn>:LIMit:DCIRcle:DISPlay[:STATe]
Limit to Circle On/Off
If enabled, only trace points within the configured "Display Circle" are shown, when-
ever the related trace is displayed in complex format. At the same time, the active limit
tests (line, circle) are restricted to the configured "Display Circle".
User Manual 1173.9163.02 ─ 62
"Global Check" on page 376.
"TTL1 Pass / TTL2 Pass" on page 376.
GUI reference
Lines softtool
(Element "Vertical
389