R&S ZNB Series User Manual page 911

®
R&S ZNB/ZNBT
Example:
Manual operation:
CALCulate:FMODel:ISD:COUPon:TYPE <CouponType>
Sets/gets the coupon type to be measured for a fixture modeling with the ISD tool.
Parameters:
<CouponType>
Example:
Manual operation:
CALCulate:FMODel:ISD:DCEXtrapolat <Boolean>
Defines whether the de-/embedding file generated by the ISD tool contains (extrapola-
ted) DC data.
Can only be set to ON, if a recent version of the ISD tool (from 2019-12 or later) is
used. ON correspons to add_dc=1 in the tool's batch mode.
Parameters:
<Boolean>
Manual operation:
CALCulate:FMODel:ISD:DUT:MEASure
For a fixture modeling with the ISD tool, this command allows to measure DUT + Fix-
ture at the active ports (see CALCulate:FMODel:ISD<Ph_pt>:DUT[:STATe])
Example:
Usage:
Manual operation:
CALCulate:FMODel:ISD:DUT:MEASure:FILename <String>
For a fixture modeling with the ISD tool, this command loads the "DUT + Test Fixture"
properties from a Touchstone file.
Parameters:
<String>
User Manual 1173.9163.02 ─ 62
See Chapter 8.2.8, "Fixture
See "Active" on page 631
SYMMetric2x | OPEN1x | SHORt1x | OPSHort1x
See Chapter 8.2.8, "Fixture
See "Coupon Type" on page 630
OFF (0)
No DC data added, i.e. the touchstone data reach down to the
start frequency of the instrument sweep.
ON (1)
The ISD tool adds (extrapolated) S-parameter data for f = 0.
*RST: OFF (0)
See "DC Extrapolation"
See Chapter 8.2.8, "Fixture
Event
See "Measure" on page 632
Path to the Touchstone file, either absolute or relative to the
selected working directory (CALCulate:FMODel:DIRectory).
Command reference
SCPI command reference
modeling", on page 1527
modeling", on page 1527
on page 638
modeling", on page 1527
911