R&S ZNB Series User Manual page 633

®
R&S ZNB/ZNBT
Figure 5-62: Save Fixture Model section
left = single-ended
right = balanced
Run <Fixture Modeling Tool>
Runs the selected fixure deembedding tool.
This button is only active, if both:
●
the test coupon measurement finished successfully or the test coupon data were
successfully loaded from file (see
on page 629)
●
the measurement of DUT + test fixture finished successfully (see
"Measure DUT + Test
The resulting Touchstone files (S parameters of the lead-ins, the lead-outs, and the de-
embedded DUT) are written to C:\Users\Public\Documents\Rohde-Schwarz\Vna
\Embedding. If result files with the same names already exist, you can decide whether
you want to rename or overwrite them.
If running the deembedding tool causes errors, the
provides additional information.
Note: For ISD first a batch task file Embeddingconfig_znb.abt is created and then
the tool is run in batch mode (see the ISD User Guide).
Remote command:
CALCulate:FMODel:ISD:RUN:RUN
CALCulate:FMODel:SFD:RUN:RUN
CALCulate:FMODel:EZD:RUN:RUN
User Manual 1173.9163.02 ─ 62
Chapter 5.13.5.2, "Measure
Fixture", on page 631)
GUI reference
Offset Embed softtool
Coupon",
Chapter 5.13.5.3,
<Deembedding Tool> Errors dialog
633