R&S ZNB Series User Manual page 867

®
R&S ZNB/ZNBT
CALCulate<Chn>:EYE:JITTer:PERiodic:FREQuency <PeriodicFrequency>
Defines the frequency of the periodic jitter in the generator simulation of the related eye
diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Periodic jitter insertion can be enabled using
PERiodic.
Suffix:
<Chn>
Parameters:
<PeriodicFrequency> *RST:
Options:
Manual operation:
CALCulate<Chn>:EYE:JITTer:PERiodic:MAGNitude <PeriodicMagnitude>
Defines the magnitude of the periodic jitter in the generator simulation of the relaed eye
diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Periodic jitter insertion can be enabled using
PERiodic.
Suffix:
<Chn>
Parameters:
<PeriodicMagnitude> *RST:
Options:
Manual operation:
CALCulate<Chn>:EYE:JITTer:PERiodic:PHASe <PeriodicPhase>
Defines the phase of the periodic jitter in the generator simulation of the related eye
diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Periodic jitter insertion can be enabled using
PERiodic.
User Manual 1173.9163.02 ─ 62
.
Channel number used to identify the active trace
10 MHz
Default unit: Hz
R&S ZNB/ZNBT-K20
See "Periodic" on page 699
.
Channel number used to identify the active trace
1 ns
Default unit: s
R&S ZNB/ZNBT-K20
See "Periodic" on page 699
Command reference
SCPI command reference
CALCulate<Chn>:EYE:JITTer:TYPE:
CALCulate<Chn>:EYE:JITTer:TYPE:
CALCulate<Chn>:EYE:JITTer:TYPE:
867