R&S ZNB Series User Manual page 917

®
R&S ZNB/ZNBT
CALCulate:FMODel:SFD...
Commands for PacketMicro's Smart Fixture De-embedding (SFD), see
www.packetmicro.com/Products/sfd-tool.html
CALCulate:FMODel:SFD:AUTO
CALCulate:FMODel:SFD:COUPon:MEASure
CALCulate:FMODel:SFD:COUPon:MEASure:FILename
CALCulate:FMODel:SFD:COUPon:MEASure:FILename:CLEar
CALCulate:FMODel:SFD<Ph_pt>:COUPon[:STATe]
CALCulate:FMODel:SFD:COUPon:TYPE
CALCulate:FMODel:SFD:DIFFcfg
CALCulate:FMODel:SFD:DUT:MEASure
CALCulate:FMODel:SFD:DUT:MEASure:FILename
CALCulate:FMODel:SFD:DUT:MEASure:FILename:CLEar
CALCulate:FMODel:SFD<Ph_pt>:DUT[:STATe]
CALCulate:FMODel:SFD:IMPedance
CALCulate:FMODel:SFD:PRESet
CALCulate:FMODel:SFD:RUN:RUN
CALCulate:FMODel:SFD<Ph_pt>:RUN[:STATe]
CALCulate:FMODel:SFD:TOTaldiffcfg
CALCulate:FMODel:SFD:AUTO <Boolean>
Enables/disables the impedance correction of the SFD tool.
This is a global setting.
Duplicate of CALCulate:FMODel:SFD:IMPedance, kept for backward compatibility.
Parameters:
<Boolean>
Manual operation:
CALCulate:FMODel:SFD:COUPon:MEASure
For a fixture modeling with the SFD tool, this command starts the measurement of the
coupon at the active ports (see
STATe]).
The coupon type can be selected using CALCulate:FMODel:SFD:COUPon:TYPE.
Usage:
Manual operation:
User Manual 1173.9163.02 ─ 62
...................................................................................... 917
....................................................................917
......................................................................... 918
....................................................................................918
.......................................................................... 919
.................................................................919
............................................................................... 920
....................................................................................920
................................................................................ 920
................................................................ 920
.............................................................................. 921
ON (1)
Impedance correction enabled
OFF (0)
Impedance correction disabled
See "Use Impedance Correction"
CALCulate:FMODel:SFD<Ph_pt>:COUPon[:
Event
See "Measure / Measure Open / Measure Short"
Command reference
SCPI command reference
.................................................... 918
.......................................... 918
.......................................................... 918
...........................................................919
.................................................919
on page 629
https://
on page 630
917