R&S ZNB Series User Manual page 400

®
R&S ZNB/ZNBT
The 10 search ranges are valid for the entire recall set. Each of them can be assigned
to any marker in the recall set, irrespective of the trace and channel that the marker
belongs to.
The default search range of any new marker is "Full Span". The analyzer provides the
greatest flexibility in defining search ranges. In particular, two search ranges can over-
lap or even be identical. The search is confined to the part of the search range that
belongs to the sweep range.
The following example shows how "Search Range"s can be used to search a trace for
several local maxima.
Note: The marker Search Ranges are identical to the evaluation ranges for trace sta-
tistics. For more information, see
on page 360.
Remote command:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:DOMain:USER[:RANGe]
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:DOMain:USER[:RANGe]
CALCulate<Chn>:MARKer<Mk>:FUNCtion:DOMain:USER:STARt
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:DOMain:USER:STARt
CALCulate<Chn>:MARKer<Mk>:FUNCtion:DOMain:USER:STOP
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:DOMain:USER:STOP
Range Limit Lines On
Displays or hides the range limit lines in the diagram area. Range limit lines are two
vertical lines at the Start and Stop values of the active search range ("Range 1" to
"Range 10").
The line color can be modified by a user-defined color scheme
Range Lines").
Remote command:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:DOMain:USER:SHOW
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:DOMain:USER:SHOW
5.7.3.3 Marker Config dialog
The "Marker Config" dialog allows you to configure the peak searches for the active
trace and all its markers.
User Manual 1173.9163.02 ─ 62
Chapter 5.5.8.2, "Evaluation Range
GUI reference
Marker softtool
dialog",
(Element "Vertical
400