R&S ZNB Series User Manual page 612

®
R&S ZNB/ZNBT
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:BALanced:DEEMbedding<LogPt>[:
STATe]
CALCulate<Ch>:TRANsform:VNETworks:BALanced:EMBedding<LogPt>[:
STATe]
File Name <i>/Swap Gates
The ellipsis button in the "File Name <i>" column is enabled as long as the selected
Balanced tab
When loading a touchstone file, the analyzer by default assumes odd ports left (VNA
side), even ports right (DUT side). However, it is also possible to instruct the analyzer
to assume an "Increasing Port Sequence", i.e. that the low port numbers are on the
VNA side. Furthermore it is possible to "Swap Gates", i.e. to instruct the analyzer to
swap the VNA and DUT side.
Note: The loaded S-parameters are stored in the active recall set. Persisted recall sets
contain the full embedding and deembedding data so that they can be transferred to
other instruments.
Remote command:
MMEMory:LOAD:VNETworks<Ch>:BALanced:DEEMbedding<LogPt>
MMEMory:LOAD:VNETworks<Ch>:BALanced:EMBedding<LogPt>
Balanced Ports
Provides access to the
port configuration.
5.13.1.6 Ground Loop panel
Allows you to activate or deactivate ground loop deembedding/embedding ("Active").
Access:
For the "1-Port Data" network type, the required touchstone file can also be selected
from here ("...").
User Manual 1173.9163.02 ─ 62
comprises a two-port or four-port data network (*.s2p or *.s4p file).
Balanced Ports dialog
Overview panel > "Ground Loop"
Offset Embed softtool
that allows you to modify the balanced
GUI reference
612