R&S ZNB Series User Manual page 903

®
R&S ZNB/ZNBT
CALCulate:FMODel:EZD:COUPon:MEASure
CALCulate:FMODel:EZD:COUPon:MEASure:FILename
CALCulate:FMODel:EZD:COUPon:MEASure:FILename:CLEar
CALCulate:FMODel:EZD<Ph_pt>:COUPon[:STATe]
CALCulate:FMODel:EZD:DCEXtrapolat
CALCulate:FMODel:EZD:DUT:MEASure
CALCulate:FMODel:EZD:DUT:MEASure:FILename
CALCulate:FMODel:EZD:DUT:MEASure:FILename:CLEar
CALCulate:FMODel:EZD<Ph_pt>:DUT[:STATe]
CALCulate:FMODel:EZD:GENerate:SIDE<1|2>
CALCulate:FMODel:EZD:IMPedance
CALCulate:FMODel:EZD:IMPedance:BWIDlimit
CALCulate:FMODel:EZD:IMPedance:REFerence
CALCulate:FMODel:EZD:PORT:ORDer
CALCulate:FMODel:EZD:PRESet
CALCulate:FMODel:EZD:RUN:RUN
CALCulate:FMODel:EZD<Pt>:RUN[:STATe]
CALCulate:FMODel:EZD:COUPon:MEASure
For a fixture modeling with the Easy De-embedding (EZD) tool, this command starts
the measurement of the symmetrical 2xThru coupon at the active ports (see
CALCulate:FMODel:EZD<Ph_pt>:COUPon[:STATe]
Usage:
Options:
Manual operation:
CALCulate:FMODel:EZD:COUPon:MEASure:FILename <String>
For a fixture modeling with the EZD tool, this command loads the coupon properties
from a Touchstone file.
Parameters:
<String>
Options:
Manual operation:
CALCulate:FMODel:EZD:COUPon:MEASure:FILename:CLEar
Invalidates the file path previously set using
MEASure:FILename.
Usage:
Options:
User Manual 1173.9163.02 ─ 62
....................................................................903
............................................................................904
.......................................................................... 904
.................................................................905
................................................................ 905
............................................................................... 906
................................................................906
..............................................................906
............................................................................906
....................................................................................907
................................................................................ 907
......................................................................907
Event
R&S ZNB/ZNBT-K210
See "Measure / Measure Open / Measure Short"
Path to the Touchstone file, either absolute or relative to the
selected working directory (CALCulate:FMODel:DIRectory).
R&S ZNB/ZNBT-K210
See "Load File / 1x Open Preset / 1x Short Preset"
CALCulate:FMODel:EZD:COUPon:
Event
R&S ZNB/ZNBT-K210
Command reference
SCPI command reference
.................................................... 903
.......................................... 903
.......................................................... 904
...........................................................904
.................................................905
on page 904).
on page 630
on page 630
903