R&S ZNB Series User Manual page 711

®
R&S ZNB/ZNBT
Access: System – [Applic] > "TDR" > "Y Axis"
This tab is only visible if the
K20 is available.
5.16.2.13 X Axis tab
The "X Axis" tab allows you to define the x axis scaling of the active diagram. The scal-
ing logic is the same as for all other diagram types, see
on page 328.
Access: System – [Applic] > "TDR" > "X Axis"
●
This tab is only visible if the
ZNBT-K20 is available.
●
If the active trace is represented as an eye diagram, the "X Axis Settings" are
grayed out, as shown above.
If the active trace is represented as a rise time or skew diagram, the "X Axis Set-
tings" allow you to adjust the center/span or start/stop, no matter if the X axis rep-
resents "Time" or "Distance" (see
5.16.3 DUT Centric application
The "DUT Centric" application provides functions for configuring and managing DUTs
and for a DUT-centric measurement setup and calibration.
User Manual 1173.9163.02 ─ 62
Extended time domain analysis
Extended time domain analysis
" Time / Distance"
GUI reference
Applic softtool
option R&S ZNB/ZNBT-
Chapter 5.4, "Scale softtool",
option R&S ZNB/
on page 419).
711